Bracing the Stud of a Stud Partition

Filed Under: Do it yourself, Home repair, Remodeling    by: ITC

With all the studs of your stud partition in place, now fit the bracing. If you intend cladding the partition with standard aft sheets of gypsum board, place the bracing in a row 4ft from the floor. If the partition is taller than 8ft, a second row of bracing should be fitted to support the upper edges of the drywall panels and the lower edges of the panels above them.

For strength, stagger the bracing above and below each other — this makes fitting easier, too — but if they are to support the edges of two sheets of drywall they must all be in line. In this case, the center line of each brace must coincide with the edges of the panels. Mark the brace positions on the studs with a pencil and level to make sure they are all horizontal.

Cut the bracing so that it is a close fit between the studs but not over-length, otherwise it will push the studs out of true.

Begin fitting the bracing at the wall end of the partition and work in towards the center. A block of wood nailed to the wall stud will support the end of the first brace while you nail through the second stud into the other end of the brace. Use two nails. Then toe-nail the inner end of the brace to the wall stud. If the bracing is to be lined up, repeat this procedure for each one; if it is to be staggered, simply drive nails through the studs into the ends of the brace.

The ends of the bracing (“header”) over a doorway must be fitted in 1 1/2in deep slots cut in the sides of the adjacent studs. Cut down the side of each slot with a back saw and remove the waste with a lin bevel-edged chisel, working in from each end, or use a double stud at the header ends to support it.

Having completed the framework, you can remove the section of sole plate from the threshold of the doorway. Simply saw through each end level with the studs on each side. Then clad the framework with gypsum board, trimming the panels round the doorway flush with the studs and header.

The door opening should be trimmed with lengths of 4 x in planed softwood that fit flush with the faces of the gypsum board panels on each side. Cut a length to fit snugly between the studs at the top and screw this to the header. Then screw two longer pieces to the studs on each side of the door opening.

Finally, cut pieces of molding to fit round the door opening, mitering their corners at 45°. Nail the molding to the edges of the trimming pieces with in finishing nails, driving their heads below the surface.

Be Sociable, Share!

Tags: , , , , , , , , , , , , , ,

Leave a Reply


2 × five =